2.7.07 Trailer coupling systems
Learn the safe coupling, checking, and uncoupling steps for trailers and semitrailers. Focus especially on play, locking, support devices, hose connections, and wear limits.
1. The golden safety rule
A drawbar or tow coupling must not have noticeable longitudinal play.
Longitudinal play can damage the final cross member/traverse and may cause the trailer coupling or trailer to tear off.
- End play in a tow coupling is not permitted.
- Longitudinal play in the trailer drawbar must be fixed immediately.
- Play in bearing bushes causes impacts and damage.
- Tyre overload is not the relevant consequence in these questions.
2. Coupling a normal trailer
- Bring the drawbar to coupling height using the trailer height adjustment.
- Reverse the towing vehicle carefully toward the trailer.
- Make sure nobody is standing between vehicle and trailer.
- The ground may be touched during the coupling process.
- Check that the coupling claw closes securely.
- Raise and secure the support wheel before driving.
- After coupling, release the trailer parking brake and remove wheel chocks.
3. Multi-axle trailer with automatic hitch
- Check that the coupling pin is fully engaged.
- Check the position of the control pin.
- The drawbar must be correctly adjusted.
- The trailer must be secured against rolling away with parking brake and/or chocks.
- The inclination angle of the drawbar is usually not the exam focus here.
Exam tip:
Automatic hitch questions often ask about the control pin and fully engaged coupling pin.
4. Air brake hose connection order
With combined coupling heads
Both lines close/connect at the same time.
Without combined coupling heads
Connect the brake line first: yellow coupling head.
Never connect coupling parts of different colours incorrectly.
5. Coupling a semitrailer
- The fifth wheel must be unlocked and opened before coupling.
- The fifth wheel and kingpin should be approximately at the same height.
- After coupling, check the fifth-wheel locking and safety system.
- Check that the lock closes automatically.
- Connect and check all hose and cable connections.
6. Uncoupling a semitrailer
- Secure the semitrailer wheels.
- Extend the support legs/support devices.
- Disconnect all hose and cable connections between tractor and semitrailer.
- Unlock and open the fifth-wheel lock.
7. Wear limits and technical checks
| Part / check | What to remember |
|---|---|
| Coupling pin height play | Maximum 4 mm play. Too high can cause jerking; too low can prevent proper engagement. |
| Coupling bolt diameter | Must not be less than 36.5 mm over the whole coupling surface. Replace if worn too much. |
| Drawbar eye wear | Maximum diameter wear: 1.5 mm. |
| Drawbar / slewing ring wear test | With trailer braked, move the towing vehicle forward briefly several times to detect dangerous wear. |
| Lower fastener guide | There must be no excessive play. |
K 80 coupling system
After coupling, lock the hold-down device and adjust the trailer coupling height to the trailer.
The K 80 system does not need lubrication before every use.
Control pin check
You can check correct engagement by looking at the control pin or the indicator light in the cab.
People safety
When reversing to couple, always pay attention to people who may be standing between the vehicle and trailer.
Fast exam checklist
Practice Questions (2)
-
Question 1 of 2
What must you consider when coupling a trailer with ball coupling?
2.7.07-2083 PointsExplanation
When coupling a trailer you have to make sure that the existing support wheel is raised before departure and secured. The coupling claw has to close securely. The ground is touched during the coupling process.
-
Question 2 of 2
What must be checked after you have coupled a multiple-axle trailer to an automatic trailer coupling?
2.7.07-2093 PointsExplanation
When coupling a multi-axle trailer to an automatic trailer hitch, you should check that the coupling pin is fully engaged and the position of the control pin is checked. The angle of inclination of the trailer drawbar does not need to be checked.